This is key for proper flow through the machine. Try cleaning with your machine. Again. If you still experience your machine not spraying. Please contact us you.

You will need to fill your clean tank again. Reseat the tank and ensure it sits snug on the machine. This is key for proper flow through the machine. If the hose still does not spray, it may have lost its prime.

This powerful carpet cleaner removes dirt from deep in the carpet fibers leaving your floors looking feeling and smelling like new i'll start by filling up the water tank. The proheat revolution has

Try stretching out the hose and giving it a few light tugs to release any kinks. Afterwards, test to see if the machine sprays. If you still cannot get your DeepClean Essential to spray, please visit BISSELL.com to find the nearest BISSELL Authorized Service Center.

Good question, this cleaner is for water extraction so it's not designed to be used for dry vacuuming.

If there is little or no water being sprayed from your machine, here are a few tips that will help. Check to see if your clean water tank is empty. The clean water tank also may not be seated properly. The brush window could also not be latched into place.

This machine uses HeatWave Technology™ which helps maintain consistent water temperature throughout the cleaning process by redirecting the heat of the motor to help maintain the temperature of the water.

Good question, this cleaner is for water extraction so it's not designed to be used for dry vacuuming.

make sure the dirty water tank plug is firmly in place on top and the black duct bill gasket is in place on the bottom before replacing the tank. now check for any cracks or clogs in the hose with the tool removed try suctioning water from a cup lift.

No, it is not recommended to be used as a regular vacuum. Sorry, there was a problem.

The ProHeat® Carpet Cleaner has a built-in heater to heat tap water up to 25 degrees hotter for optimum cleaning.

Here's some tips to fix that.

1. Check to make sure the Vacuum Suction Knob is turned towards "Floor Suction."
2. Or there could be large debris clogging the brush roll rotation.
3. Your dirt container may not be seated properly or may be full.
4. The main hose needs to be connected.