So you can clean the blade. Using the small cleaning brush sweep the remaining hair out of the blade. If there is still residue you can run the blade under water and rinse clean and towel dry.

For excess hair clippings, the blade head (removed off the unit) and comb attachments can be rinsed under running water and placed on a towel to dry. Be sure the blade head is completely dry before putting it back on. The handle can be cleaned with a damp cloth, do not submerge under water.

On. Place the razor head above the area you want to trim. And slowly move down the desired trim. Area continue with an up-down motion until the desired length is achieved.

Shave, Trim and Edge with micro precision with Micro Touch Solo. To replace head, gently push the blade release up and hold onto the blade to prevent falling. Hold the new blade by its sides and press onto the handle. There will be a click when the blade is secure.

For titanium rings, the cleaning process is a lot easier than you expect. Fill a blow with Luke warm water and mild dishwashing liquid. Allow your right to soak for 3-5 minutes. With a cloth, gently rub off any dirt and grime, followed by rinsing with warm water.

Nitric acid is an excellent passivating agent for titanium and may be used alone or with hydrochloric acid to clean titanium surfaces.

Apply a dab of liquid soap to the cutting surfaces, and then run the razor for about 15 seconds before rinsing it out. After rinsing, take the block apart again, and let all of the components air-dry completely.

Fill up your applicator with vegetable or olive oil and add a few drops directly to the blades. Grab a toothbrush and spread over the clippers blades (or turn on for a few seconds for a speedy distribution). Wipe away any excess oil and then store your device away from moisture and dust.

MicroTouch Titanium MAX is your multi-purpose personal grooming device that goes where other trimmers can't. Easily clean up necklines, sideburns, eyebrows, nose and ear hair, and more.

So you can just drop it in here. Take it out and start using it. Again. Now I'm just gonna give myself a little shave here just to show you how easy this is turn it on and just start. Going.

How often should I change the screens and blades? All major manufacturers recommend you change your shaving heads every 12 to 18 months, with daily cleaning. For Braun, Panasonic, and Remington foil shavers, this means changing both the blades and the screen or foil at the same time.

This video shows you how to replace the shaving heads of your Philips Shaver S5000 and S7000.

1. Turn off the shaver and release the shaving head holder.
2. Remove the retaining rings.
3. Remove the shaving heads from the holder.
4. Put the new shaving heads in the holder.
5. Put the retaining rings back on and fix them.