Sometimes the battery may have gotten dirty or slipped away from its contacts inside the Shark robot vacuum. Cleaning and repositioning it may fix your problem. But if it's an old battery or there are clear signs of damage, you should order a replacement battery that matches your model.

Completely before reinserting. The self-cleaning brush roll actively removes hair wrap while your robot cleans.

For the standard plug insert the charge plug into the port. Make sure to lean or hang up your vac mop while charging. When it begins charging you'll see a green light flashing.

Off to attach the pad to the fluid. Reservoir. Slide it in the slot on the edge of the tank with your hand secure to the bottom of the reservoir. And fold the tap over to the back.

There are a few common reasons for unexplained stops in robot vacuum cleaners. These include an unhealthy battery, sensor issues, an obstruction of the brush, suction or wheels; software updates, malfunctioning motors, a full dust bin, or overheating.

Check for a clogged hose or filter; unclog the hose and replace the filter. Wait 45 minutes for the vacuum to cool; then plug in the vacuum. Turn the power switch to the “I-On” position to start the vacuum. If the vacuum still does not start, contact Customer Service at 1-800-798-7398.

And then slide the dust cup. Out then over a trash can press the release. Button on the bottom of the bin.

Filter. Again be sure to hand wash with cold water only and make sure to air dry. Completely before reinstalling.

The green charge light stops flashing Once the product is fully charged the light stops flashing and glows green.

Charge Indicator Lights: The charge indicator lights on your robot show how much battery power remains.

1. Both LEDs are blinking in sequence: Your robot is charging; allow your robot to charge at least three hours between cleaning missions.
2. Both LEDs are solid white: Your robot is fully charged and ready to clean.

Your first charge can take up to six hours once your robot is fully charged the battery indicator will remain solid. White for best. Results.

Press the power button on the side of the ROBOT to the OFF position for 10 seconds. Press it again to turn power back ON.