And as you can see I'm making it auto level even more by turning it counterclockwise. I'm going to turn it clockwise. Now. And what we're going to do is. It's going to become level.

Press and hold the manual control button on the headrail for 12 seconds at 6 seconds the window covering will jog. Continue holding until it jogs a second time at 12 seconds. On the second jog all

So you'll push the dial in and turn it to level your shade. Do this until your shade is level. If for some reason your shade doesn't have the plastic tool you can do this with a flathead.

And slow it down as you prefer. Okay with our shade installed. You can make your adjustments. Without taking the shade assembly down you can reach up to the right to access the stop adjustment.

My blind is stuck in the raised position. Some heavier and larger blinds can get stuck if they are pulled up very tightly. To help release the lock, place your hand on the middle of the bottom rail and push up while simultaneously trying to unlock the blind cord. Usually, this extra support does the trick.

Is we'll find the power button and on the roller shade it's here on the bottom. We'll press and hold for about six seconds and after that six seconds you'll see the shade jog.

By the tube that this occurs in so I'm loading this spring up down the length of this product.

Fixing Cordless Roller Blinds Take the shade down and manually unroll it to the halfway point, then turn the pin on the spring side of the blind until tension returns.

And we're going to do this evenly on each side symmetrically. So that the shade isn't crooked. And then screw it back on and it should work perfectly. Fine.

So this is a top-down bottom-up shade if you have a top-down shade. And it gives a little crooked. Okay all you got to do is grab that rail. Level it back out raise. It up and you're good to go okay.

You raise it back up. And we'll stay right where it's supposed to so again let's pull it down. About 45 degrees away from the window frame. And pull downwards. Left a vaca then you're good to go.

And washers and not them reinsert the end caps to complete your repair. Finish by installing your blind and testing the operation of your new tilter. If you have a wand tilt lift.