As a WaterFurnace unit runs, it can capture heat that would normally go to waste and divert it to your water heater tank (using an optional component called a desuperheater). Your unit can generate up to 50% of your hot water - at almost no cost. For larger volumes of hot water, we also offer dedicated hydronic units.

E10, Compressor Monitoring - Fault is recognized when the compressor has an open circuit, potential welded contactor.

WaterFurnace residential geothermal heat pumps keep homes comfortable in every climate. That's because we unlock the free, renewable solar energy that's stored in the ground. WaterFurnace delivers comfort the natural way - and cuts your energy bills by up to 70% in the process.

If my WaterFurnace shuts off, how do I reset it? To reset the unit, repeatedly push the SYSTEM button on the thermostat until the display reads OFF. The unit lockout indicator light will remain on for up to 15 seconds after turning the system off.

Geothermal Benefits. WaterFurnace systems are rated number one in energy efficiency because they can deliver more than five units of energy for every one unit of electrical energy used. Compare that to even the best ordinary system that delivers less than one unit of energy for every unit it consumes.

A WaterFurnace geothermal system operates more efficiently than ordinary heating and air conditioning systems because it can deliver an astounding five units of energy for every one unit of electrical energy used.

The Bosch error code E10 indicates one of two things. Either your system's heating element is faulty, or there is a problem with the high limit safety cut-out. There are no trouble-shooting steps for either of these issues, so it is recommended that you contact a qualified professional for assistance.

The E10 code typically is associated with high pressure, with the video explaining common causes and what actions you can take.

If your water heater loses power, your water heater's reset button can be used to turn the appliance back on. However, your reset button serves as a safety device and turns the unit off when the water temperature gets too hot.

And the reset button is located under the top one I have two screws here but you may have just one unscrew the panel and remove the insulation. My insulation is made of fiberglass.

Electric heat-pump water heaters A heat-pump water heater uses heat from the surrounding air to heat water in a storage tank. An electric heat-pump hot water heater uses much less electricity than an electric storage water heater, and are the most efficient hot water systems on the market.

Horizontal loops: This is the most common type of loop system, and if a home has sufficient space and the right weather conditions, horizontal loops are usually the number one choice for geothermal installation. They are highly efficient and also easy to repair.