And litter to the globe. Clean or move the unit. There are other factors that may affect the cap some series abilities to get an accurate measurement. So be sure to check your units of the following.

Now. Let's run a test cycle. Short press the reset. Button. Then short press the cycle button to run a clean cycle.

Check for Obstructions Make sure the Litter-Robot is on a firm, level surface. The Cat Sensor function can be affected if the rear feet of the unit are on carpeting or a litter mat. Check that there are no power cords running underneath the base of the robot that might obstruct movement.

Litter-Robot 3 is equipped with infrared emitters and sensors located above the Waste Drawer that check if the drawer is full each time the Globe returns to the Home position. Once a full Waste Drawer is detected, the unit will indicate it is full with a blue flashing light.

On the gear icon in the top right corner. On the robot settings screen tap. On firmware information on the information page tap update firmware to begin the update. Process.

Cover locate the cat sensor and unplug it Kludd the new cat sensor. Install it back in its spot.

It along gently. But firmly all the way to the edge. Pull. It out turn it 180 degrees. Use the clean side and in the same direction wipe the image sensor.

Whether or not Litter-Robot will be comfortable for a large or fat cat is up to the individual. As long as the cat can enter the globe and turn around inside it comfortably, it doesn't matter how much they weigh.

Short press the Reset button, then short press the Cycle button to run a Clean cycle.

The pinch sensor is located in the base. Look at the top of the base, and locate the plastic pinch bar on the left side of the waste port opening. Press the bar inward several times to dislodge any built-up litter or debris. Rotate the base so the waste port opening is facing up.

We want to disconnect these two black wires from the pinch German. Using your needle nose pliers generally grab on to each of the pinched contacts. And lift wiggle and lift out of the assembly. To

• Turn off the camera power. Detach the lens. Use the blower to clean the image sensor surface and the surrounding area.
• Attach the lens to the camera.
• You can recheck if dust appears with " How to check for dust attached to the image sensor ". Releasing the shutter several times may drop the dust.