Plus the edge guide is reversible. So the RIP cut works equally well right-handed. And left-handed mounting your saw on the RIP cut is quick and easy and your song can be removed for other uses. Then

The Rip-Cut easily makes straight, accurate, repeatable cuts without measuring, marking, or having to keep the saw on the cut line. The Rip-Cut does this with a long edge guide that follows the straight edge of the sheet you are cutting.

The saw sled and slide the guide rail over until the guide arm. Just touches the saw blade. Now lock the RIP cut down. All you have to do now is press the release. And slide the cursor.

The RIP cut uses an edge guide that follows the edge of the sheet as you push the saw along the saw rides on an aluminum arm that's attached to the edge guide. So with the RIP cut you can easily cut a

Premium Plunge-Cutting Circular Saw: Gives you perfectly straight cuts without splinters or chips. Cut Precisely, Every Time: Cut through plywood, solid wood, panels, and more with ease and precision. Adjustable Track Saw: Cut from 2 1/8 inches at 90° to 1 1/2 inches at 45°; works with Kreg 62-inch Guide Track.

Then we'll tighten the screw with the hex. Wrench. Next we'll set the thickness stops. Just press the gray tabs and push the stops to match the thickness of our material. Now we can add the clamp pad.

And it can vary by model but most fences are reversible. So you can actually mount it to either side of the saw. As it sounds the rip fence serves as a guide for a rip.

Crosscutting is cutting across the grain of dimensional wood like framing lumber, molding or fence posts. Ripping is cutting in the same direction as the grain in dimensional wood and is best done with a dedicated ripping blade.

Manual circular saws, miter saws, hand saws, and reciprocating saws all have their place and can produce an amazingly wide variety of cuts. But when it comes to making a length-wise rip cut in wood, a table saw is the best tool to do it accurately while producing cuts that look like factory edges.

Since our humble beginning as a family-owned company in 1989, the Kreg name has become synonymous with pocket-hole joinery. Woodworkers of all skill levels have come to trust our products time and time again. Pocket-Hole Jigs. Jig System Components. Pocket-Hole Screws & Plugs.

In general all rip saws are designed around a single circular saw blade with guarding and extraction, a fence and a machine table of varying sizes. The saw blade can be raised and lowered to match the material being processed while some machines also allow the blade to cant to 45 degrees.

With the yank you cut you eliminate the hassles inaccuracies. And inconsistencies of needing to mark a long cut line and then trying to freehand the saw along it. Just make a couple of marks.